Lutron Electronics RadioRA - Copying Button Programming

RadioRA® Setup Guide2-5
Step 1 Begin Copying Button
Programming
Copying Button Programming
If you have more than one Master Control in your system, you can copy the button programming from a
previously programmed Master Control button to an un-programmed Master Control button so that both buttons
function identically.
Step 2 Select the button you want to
program
Advanced Programming
Section 2 - Advanced Features
On the Master Control you want to program,
simultaneously press and hold the 1st and 5th
buttons in the right most column until the
upper right LED begins to blink (approximately
3 seconds).
Press and release the button you want to
program. Its LED will begin to blink.
Un-programmed
Master Control
ALL ON
ALL OFF
Tabletop Master Wall Master
OR
Un-programmed
Master Control
Upper right LED blinks.
Note: LEDs on all other Master Controls will
flash.
Un-programmed
Master Control
Un-programmed
Master Control
The programming from a ROOM button cannot
be copied to a SCENE button, or vice versa.
LED blinks.