RadioRA® Setup Guide 2-6
Step 3 Select the button you want to
copy
Step 4 Complete Copy Button
Programming
Advanced Programming
Section 2 - Advanced Features
On a previously programmed Master Control,
press the programmed button that you want to
copy until its LED turns OFF (approximately 3
seconds).
Simultaneously press and hold the 1st and 5th
buttons in the right most column until all LEDs
begin to flutter (approximately 3 seconds).
• Repeat Steps 2 and 3 for all Master
Control buttons that you want to copy
programming to.
When the LED turns OFF
for a few seconds and
then resumes flashing
programming has been
copied to
Previously Programmed
Master Control
Previously Programmed
Master Control
• Repeat Steps 1 through 4 to copy button
programming on any remaining
unprogrammed Master Controls.
Newly Programmed
Master Control
Newly Programmed
Master Control
To Next Page
Loading...
