Lutron Electronics RadioRA Setup Guide

RadioRA® Setup Guide
Section 4 - Troubleshooting
4-8
Returning Components to Default Factory Settings
Switches
Returning a Switch to Default Factory Settings will permanently delete all current programming information.
Do not do this unless you are sure that it is necessary. For more information call the Lutron Technical
Support Center.
Step 1 Turn FASSTM switch OFF Step 3 Return to Default Factory
Settings
The light the Switch controls will turn ON and
OFF a few times indicating that the Switch
was returned to Default Factory Settings.
Release and then press and hold the paddle
switch for 2 seconds.
Ensure that the ACTIVATE REPEATER LED or
ACTIVATE CONTROLS LED on any Repeater
is NOT ON before proceeding. If either LED is
ON, press the corresponding button until it's
LED turns OFF (approximately 3 seconds).
Slide the Front Accessible Service Switch
(FASSTM) to the left.
If the LED does not flash, continue with
Step 3, then repeat Steps 1-3 again.
Step 2 Turn FASSTM switch back ON
Press and hold the paddle switch while turning
the FASSTM switch ON until the LED begins to
flash. The light the Switch controls will remain
OFF.

Lutron Electronics RadioRA Specifications

General

Brand	Lutron Electronics
Model	RadioRA
Category	Control Systems
Language	English