Lutron Electronics RadioRA - GRAFIK Eye Interface

RadioRA® Setup Guide4-9
Returning Components to Default Factory Settings
Section 4 - Troubleshooting
GRAFIK Eye® Interface
Returning a GRAFIK Eye® Interface to Default Factory Settings will permanently delete all current
programming information. Do not do this unless you are sure that it is necessary. For more information
call the Lutron Technical Support Center.
Step 1 Remove faceplate
Step 2 Return to Default Factory
Settings
Press and hold the ON/OFF button until the
orange LED begins to blink (approximately 5
seconds).
The GRAFIK Eye® Control Unit that was
controlled by this GRAFIK Eye® Interface will
turn ON and OFF a few times indicating that
the interface has been returned to Default
Factory Settings. Reattach the faceplate.
Ensure that the ACTIVATE REPEATER LED or
ACTIVATE CONTROLS LED on any Repeater
is NOT ON before proceeding. If either LED is
ON, press the corresponding button until it's
LED turns OFF (approximately 3 seconds).
Remove the faceplate from the GRAFIK Eye®
Interface.
ON/OFF
60 HZ
GRX Accessory Control Address 15
1234
COM V+ MUX MUX
WH RED YEL BL
50 HZ
ON/OFF
60 HZ
GRX Accessory Control Address 15
1234
COM V+ MUX MUX
WH RED YEL BL
50 HZ