Lutron Electronics RadioRA - Setting Light Levels;Grafik Eye

RadioRA® Setup Guide 3-10
Section 3 - Expanding Your System
Adding a Switch Closure Interface
Setting Light Levels/GRAFIK Eye® Scene Selection for
Input Channels
Note: Dimmers can have a variable light level set or turned OFF. Switches can be turned ON or OFF. GRAFIK
Eye® Control Units can be set to any scene or turned OFF.
Step 1 Begin setting light levels/
GRAFIK Eye® Scene Selection
18V
AC IN
Full Flash Input 1 Input 2 Input 3 Input 4 Input 5 Common
See
the
S
w
itch
Clos
u
re
Interface
Addend
u
m
to
the
Programming
Guide for operating instructions.
For additional assistance call the Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
18V
AC IN
Full Flash Input 1 Input 2 Input 3 Input 4 Input 5 Common
In ut
5
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline: 1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
Program LED blinks. Input 1 LED and a
Closure Type LED will turn ON.
Dimmers assigned to Input 1 will turn ON to
50% light level. Switches assigned to Input 1
will turn ON. GRAFIK Eye® Control Units
assigned to Input 1 will turn ON to scene 1.
Dimmers, Switches or GRAFIK Eye® Control
Units not assigned to Input 1 will turn OFF.
Step 2 Select an Input Channel to
program
Selected Switch Closure Input Channel will
have its LED ON.
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
18V
AC IN
Full Flash Input 1 Input 2 Input 3 Input 4 Input 5 Common
18V
AC IN
Full Flash Input 1 Input 2 Input 3 Input 4 Input 5 Common
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the Lutron Technical Assistance
Hotline: 1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
Note: Light levels cannot be set for FULL and FLASH
dedicated security inputs. The default for these inputs
is, Dimmers and Switches - ON at 100%, GRAFIK
Eye® Control Units - ON to scene 1.
Note: Closure Type may not be changed while setting
light levels.
• Continued on next page.
Press and hold the Program button until the
Program LED begins to blink (approximately 3
seconds).
Press and release the Input Select button until
the LED for the desired input channel turns
ON.