RadioRA® Setup Guide3-11
Section 3 - Expanding Your System
Adding a Switch Closure Interface
To set the light level for another Input
Channel, press the Input Select button to turn
that channel's LED ON.
18V
AC IN
Full
Flash
Input 1
Input 2
Input 3
Input 4
Input 5
Common
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
Step 4 Select next Input Channel to
program
Step 3 Set light levels/select GRAFIK
Eye® scenes
Go to any assigned Dimmer (which will be
ON at 50%). Adjust this Dimmers programmed
light level for the selected SCENE button
using the dimming rocker, or turn the Dimmer
OFF if it is to be turned OFF when this Input
Channel is activated.
Adjust light levels
Turn OFF
OR
LUTRON
Go to any assigned GRAFIK Eye® Control
Unit (which will be ON at scene 1). Select from
pre-programmed scenes (1 through 4) by
turning that scene ON or select OFF if it is to
be turned OFF when this Input Channel is
activated.
Go to any assigned Switch (which will be
ON). Turn the Switch OFF if it is to be turned
OFF when this Input Channel is activated.
Selected Switch Closure Input Channel will
have its LED ON.
18V
AC IN
Full
Flash
Input 1
Input 2
Input 3
Input 4
Input 5
Common
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
To Next Page
Loading...
