Lutron Electronics RadioRA - Diagnostic Tools BEEP Mode

RadioRA® Setup Guide4-3
Diagnostic Tools
Section 4 - Troubleshooting
Step 1 Enter BEEP Mode
BEEP Mode
BEEP Mode is used to verify that a Repeater can 'hear' a particular Control.
Step 3 Repeater response
BEEP
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
LUTRON
Step 4 Exit BEEP Mode
Green BEEP LED on that Repeater will go
OFF. MAIN or AUXILIARY LED will stay
ON.
If the Repeater does not beep, the Dimmer,
Switch, GRAFIK Eye® Control Unit or Master
Control is out of RF communication range of the
Repeater. The Repeater must be moved closer
to the control, or another Repeater must be
added to the system.
Press and hold the BEEP button on the
Repeater you are checking until the green
BEEP LED turns ON (approximately 3
seconds).
If the Repeater can ‘hear’ the control, it will
produce multiple audible beeps immediately
after the button is pressed.
Press and hold the BEEP button on the
Repeater you are checking until the green
BEEP LED turns OFF (approximately 3
seconds).
RF Signal
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
Green BEEP LED on that Repeater only
will be ON.
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
Step 2 Check a Control
Turn the Dimmer, Switch or GRAFIK Eye®
Control Unit ON or OFF, press the ALL ON or
ALL OFF button on a Master Control.