RadioRA® Setup Guide4-7
Section 4 - Troubleshooting
Returning Components to Default Factory Settings
Dimmers
Returning a Dimmer to Default Factory Settings will permanently delete all current programming
information. Do not do this unless you are sure that it is necessary. For more information call the
Lutron Technical Support Center.
Step 1 Turn FASSTM switch OFF
Ensure that the ACTIVATE REPEATER LED or
ACTIVATE CONTROLS LED on any Repeater
is NOT ON before proceeding. If either LED is
ON, press the corresponding button until it's
LED turns OFF (approximately 3 seconds).
Slide the Front Accessible Service Switch
(FASS
TM) to the left.
If the LEDs chase downward, continue
with Step 3, then repeat Steps 1-3
again.
Step 2 Turn FASSTM switch back ON
Press and hold the raise rocker and the
paddle switch while turning the FASSTM switch
ON until the LEDs begin to chase upward.
Step 3 Return to Default Factory
Settings
While the LEDs are chasing upward,
simultaneously press and release the lower
rocker and the paddle switch.
The light that the Dimmer controls will turn ON
and OFF a few times indicating that the
Dimmer has been returned to Default Factory
Settings.
To Next Page
Loading...
