RadioRA® Setup Guide 4-6
Returning Components to Default Factory Settings
Section 4 - Troubleshooting
Switch Closure Interface
Returning a Switch Closure Interface to Default Factory Settings will permanently delete all current
programming information. Do not do this unless you are sure that it is necessary. For more information
call the
Lutron Technical Support Center.
Step 1 Begin returning to Default
Factory Settings
Step 2 Complete returning to Default
Factory Settings
18V
AC IN
Full
Flash
Input 1
Input 2
Input 3
Input 4
Input 5
Common
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
All LEDs (except the Power LED) will turn OFF
indicating that the Switch Closure Interface
has been returned to Default Factory Settings.
Ensure that the ACTIVATE REPEATER LED or
ACTIVATE CONTROLS LED on any Repeater
is NOT ON before proceeding. If either LED is
ON, press the corresponding button until it's
LED turns OFF (approximately 3 seconds).
Press and hold the Program and Closure Type
buttons until the Switch Closure Interface
resets (all LEDs will flash).
18V
AC IN
Full
Flash
Input 1
Input 2
Input 3
Input 4
Input 5
Common
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
Press and hold all three buttons until Input
LEDs 1, 4, and Flash begin to flash
(approximately 3 seconds).
18V
AC IN
Full
Flash
Input 1
Input 2
Input 3
Input 4
Input 5
Common
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
18V
AC IN
Full
Flash
Input 1
Input 2
Input 3
Input 4
Input 5
Common
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
To Next Page
Loading...
