Lutron Electronics RadioRA - Assigning a Column of Buttons as ROOMS or SCENES

RadioRA® Setup Guide
Programming Preparations
Assigning a Column of Buttons as ROOMS or SCENES
Each column of buttons on a Master Control can be programmed to be either ROOM or SCENE buttons.
1-7
If the first LED in a
column is flashing, the
buttons in that column
are set as ROOM
buttons.
If the second LED in a
column is flashing, the
buttons in that column
are set as SCENE
buttons.
ROOMS SCENES
Column of
Buttons
Step 1 Begin ROOM/SCENE
assignment
Simultaneously press and hold the 3rd, 5th,
and ALL OFF buttons in the right most column
until an LED in each column of the Master
Control which you are programming begins to
flash (approximately 3 seconds).
Note: On a 5 button Raise/Lower Wall Master,
press and hold the 3rd, 5th, and Lower
buttons.
Tabletop Master Wall Master
OR
What is a ROOM button?
ROOM buttons can be used to turn a light or a group
of lights ON or OFF. Pressing a ROOM button once
will turn ON all Dimmers or Switches assigned to that
button to their pre-selected light level. Pressing the
same ROOM button again will turn OFF all Dimmers or
Switches assigned to that button. A ROOM LED will be
ON if any Dimmer or Switch assigned to that button is
ON, regardless of its light level.
What is a SCENE button?
SCENE buttons can be used to direct any combination
of Dimmers and/or Switches to a pre-selected state or
light level. Pressing a SCENE button once will turn ON
any Dimmers or Switches assigned to turn ON, and
turn OFF any Dimmers or Switches assigned to turn
OFF. Pressing the same SCENE button again will turn
OFF all Dimmers or Switches assigned to that button.
A SCENE LED on a Master Control will be ON if, and
only if, that SCENE button was pressed on that Master
Control. An example of a SCENE application could be
a button called "BEDTIME", which when pressed all
interior lights would turn OFF and selected outside
lights would turn ON.
Section 1 - Start-Up
All button columns are factory set as ROOM
buttons.
Changing a column assignment from ROOM to
SCENE (or vice versa) will delete all previous
programming in that column of buttons.