Lutron Electronics RadioRA - Using Radiora Master Controls with Raise;Lower

RadioRA® Setup Guide5-1
Section 5 - Miscellaneous
On Master Controls equipped with Raise/Lower buttons, you can remotely adjust the light levels of all the
Dimmers, and GRAFIK Eye® Interfaces assigned to a particular Master Control button.
How Raise/Lower works
The Raise/Lower buttons affect a specific Master
Control button. By default the upper right-hand button
on the Master Control. As an example, if the Dimmer
in the Kitchen were assigned to the upper right-hand
button on the Master Control, pressing the Raise
button would increase the light level of the Kitchen’s
Dimmer.
How LED status is affected
If you Raise a Dimmer that is initially OFF, the Dimmer
will turn ON and increase its intensity to the desired
level. Three seconds after the Raise button is
released, the Dimmer’s status will be broadcast to the
entire system. Any Master Control ROOM LEDs, which
have that Dimmer assigned to them, will turn ON since
that Dimmer is now ON. Any Master Control SCENE
LEDs, which have that Dimmer assigned to them, will
turn OFF since the lights are no longer at their preset
level for that SCENE.
System Functionality
The Raise/Lower buttons are designed to work with
RadioRA® Dimmers and GRAFIK Eye® Interfaces only.
RadioRA® Switches are not affected by Raise/Lower.
Dimmers or GRAFIK Eye® Interfaces which have OFF
as their preset level for a particular Scene will not be
affected by Raise/Lower commands when the Raise/
Lower buttons are affecting that Scene. Dimmers
cannot be lowered to OFF.
Note: The functionality described above pertains to
RadioRA® Dimmers and Switches which shipped after
January 1, 2001 and GRAFIK Eye® Interfaces which
shipped after February 1, 2001. Contact the Lutron
Technical Support Center at 1-800-523-9466 for
information on using Raise/Lower Master Controls with
older dimming devices.
Raise
Lower
How to change which Dimmers you raise
or lower
You can easily change which Master Control button is
affected by the Raise/Lower button, quickly tap twice
the Master Control button that you want to be affected
by the Raise/Lower buttons. That Master Control
button’s LED will blink for about 2 seconds to indicate
that the Raise/Lower buttons are now affecting that
Master Control button.
Using RadioRA® Master Controls with Raise/Lower
Tap twice
quickly