Lutron Electronics RadioRA - Adding Basic System Components; Adding an Auxiliary Repeater

RadioRA® Setup Guide3-1
Adding an Auxiliary Repeater
Auxiliary Repeaters (up to a maximum of 3) can be added to a system to increase range and improve reliability.
Ensure all system devices are powered up and operating prior to adding any Auxiliary Repeaters.
Adding Basic System Components
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
?
Step 1 Begin Auxiliary Repeater
Activation
If the ACTIVATE REPEATER LED turns
orange, consult the Troubleshooting Guide,
Sections I.
Green Activate Repeater LED will turn ON on
all existing system Repeaters.
Step 2 Activate Auxiliary Repeater
If the ACTIVATE REPEATER LED turns
orange, consult the Troubleshooting Guide,
Section I, II or III.
?
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
Green LED will stay ON when Repeater has
been activated.
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
Press and hold the ACTIVATE REPEATER
button on the new Auxiliary Repeater until the
green ACTIVATE REPEATER LED begins to
flash (approximately 3 seconds).
Section 3 - Expanding Your System
Press and hold the ACTIVATE REPEATER
button on any previously activated Repeater
until the green ACTIVATE REPEATER LED
turns ON (approximately 3 seconds).