RadioRA® Setup Guide 2-8
Advanced Programming
Step 3 Erase button
While the LED is fluttering, press the ALL OFF
or Lower button in the right most column.
Step 4 Complete Erasing Button
Programming
Simultaneously press the 2nd and 4th buttons
in the right most column until all LEDs begin to
flutter (approximately 3 seconds).
Section 2 - Advanced Features
The LED will stop fluttering and begin to flash.
All Dimmers and/or Switches will turn OFF,
and programming is now erased from that
Master Control button.
• Repeat Steps 2 and 3 for all Master
Control buttons with programming that
you want to erase.
Wall MasterTabletop Master
OR
To Next Page
Loading...
