RadioRA® Setup Guide3-7
Section 3 - Expanding Your System
Adding a Switch Closure Interface
Step 1 Begin assigning Dimmers,
Switches or GRAFIK Eye®
Control Units to Input
Channels
Assigning Dimmers, Switches or GRAFIK Eye® Control
Units to Input Channels
Programming the Switch Closure Interface to control a light or a group of lights by a specified Input Channel.
Step 2 Select an Input Channel to
program
Press and release the Input Select button until
the LED for the desired input channel turns
ON.
Selected Switch Closure Input Channel will
have its LED ON.
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
18V
AC IN
Full
Flash
Input 1
Input 2
Input 3
Input 4
Input 5
Common
18V
AC IN
Full
Flash
Input 1
Input 2
Input 3
Input 4
Input 5
Common
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
Simultaneously press and hold the Program
and Input Select buttons until the Program
LED begins to flash (approximately 3
seconds).
18V
AC IN
Full
Flash
Input 1
Input 2
Input 3
Input 4
Input 5
Common
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
Program LED flashes. Input 1 LED and a
Closure Type LED will turn ON.
18V
AC IN
Full
Flash
Input 1
Input 2
Input 3
Input 4
Input 5
Common
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
Program LED
To Next Page
Loading...
