Lutron Electronics RadioRA

To Next Page

To Previous Page

RadioRA® Setup Guide 3-6

Adding a Switch Closure Interface

Section 3 - Expanding Your System

Step 3 Complete Switch Closure

Interface activation

Press and hold the ACTIVATE CONTROLS

button on any Repeater until the green

ACTIVATE CONTROLS LED turns OFF

(approximately 3 seconds).

• The Switch Closure Input Interface is

now activated.

• If you want to Verify that your Switch

Closure Interface has been activated,

see Flash Mode in the Troubleshooting

Section on page 4-4.

• Proceed to Assigning a Dimmers,

Switches or GRAFIK Eye® Control Units

to Input Channels on page 3-7.

MAIN

REPEATER

CONTROLS

ACTIVATE

BEEP

FLASH

VERIFY

AUXILIARY

The green ACTIVATE CONTROLS LED on

ALL

Repeaters will turn OFF. The MAIN or

AUXILIARY LED will remain on.