RadioRA® Setup Guide 4-10
Returning Components to Default Factory Settings
Section 4 - Troubleshooting
Repeaters
Returning a Repeater to Default Factory Settings will permanently delete all current programming
information. Do not do this unless you are sure that it is necessary. Return all other devices in your
system to Default Factory Settings before returning your Main Repeater to Default Factory Settings. For
more information call the
Lutron Technical Support Center.
Step 1 Begin returning to Default
Factory Settings
Step 2 Complete returning to Default
Factory Settings
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
Release both buttons. All LEDs will flash once
and only the AUXILIARY LED will stay ON,
indicating that the Repeater has been returned
to Default Factory Settings.
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
While holding the BEEP button, press and hold
the ACTIVATE REPEATER button until the
ACTIVATE REPEATER LED flashes alternately
green and orange.
Ensure that the ACTIVATE REPEATER LED or
ACTIVATE CONTROLS LED on any Repeater
is NOT ON before proceeding. If either LED is
ON, press the corresponding button until it's
LED turns OFF (approximately 3 seconds).
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
Press and
hold
(do not release) the BEEP
button. The green BEEP LED will turn ON
after approximately 3 seconds.
To Next Page
Loading...
