Lutron Electronics RadioRA - Page 35

RadioRA® Setup Guide 3-8
Section 3 - Expanding Your System
Adding a Switch Closure Interface
Step 4 Select Input Channel switch
closure type
Step 3 Assign Dimmers, Switches or
GRAFIK Eye® Control Units to
Input Channel
To assign an input channel switch closure
type, press the Closure Type button to toggle
between a Momentary and a Maintained input.
Note: Momentary inputs must be closed for a
minimum of 100 msec.
• Continued on next page.
18V
AC IN
Full Flash Input 1 Input 2 Input 3 Input 4 Input 5 Common
FCC
ID
JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents
Pending
Maintained
Momentary
Activate
Switch
Release
Switch
Switch
Open
Momentary Input Example
A Momentary switch closure will turn a SCENE
ON. The input SCENE remains ON after the
switch closure has been released, until the
status of a Dimmer or Switch in that SCENE is
changed.
Activate
Switch
Release
Switch
Switch
Open
A Maintained switch closure will turn an input
SCENE ON. Input SCENE remains ON until
the switch closure is released. When released,
the input SCENE returns to OFF..
Maintained Input Example
• Inputs 1 through 5 can be independently
selected as Maintained or Momentary.
• Full and Flash are Maintained closures and
cannot be changed.
In this Step you must not only assign light
controls which you want to turn ON when
the Input Channel is selected, you must also
assign light controls which you want to turn
OFF when the input channel is selected.
Assign a Dimmer or Switch to the selected
Input Channel by turning the Dimmer or
Switch ON.
Switch
OR
Dimmer
Assign a GRAFIK Eye® Control Unit to the
selected Input Channel by changing the scene
of the GRAFIK Eye® Control Unit.
LUTRON
Note: GRAFIK Eye® Control Units will automatically
turn ON to scene 1 once assigned.
If you assign the wrong Dimmer,
Switch or GRAFIK Eye® Control Unit to
a Input Channel, turn the Dimmer,
Switch or GRAFIK Eye® Control Unit
OFF to unassign it.