Lutron Electronics RadioRA - Page 36

RadioRA® Setup Guide3-9
Section 3 - Expanding Your System
Adding a Switch Closure Interface
Step 5 Select next Input Channel to
program
Step 6 Complete assigning Dimmers,
Switches or GRAFIK Eye®
Control Units to Input
Channels
Perform Steps 3 and 4 for this newly selected
Input Channel.
• Proceed to Step 6 when all Input
Channels on the Switch Closure
Interface have been programmed.
To assign Dimmers, Switches or GRAFIK
Eye® Control Units to another Switch Closure
Input Channel, press and release the Input
Select button until that channel's LED turns
ON.
18V
AC IN
Full Flash Input 1 Input 2 Input 3 Input 4 Input 5 Common
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
18V
AC IN
Full Flash Input 1 Input 2 Input 3 Input 4 Input 5 Common
In ut
5
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline: 1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
18V
AC IN
Full Flash Input 1 Input 2 Input 3 Input 4 Input 5 Common
In ut
5
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
Press and hold the Program and Input Select
buttons until the flashing Program LED turns
OFF (approximately 3 seconds).
All Input LEDs will flutter for a few seconds
when completing.
• Proceed to Setting Light Levels/GRAFIK
Eye® Scene Selection on page 3-10.