RadioRA® Setup Guide 3-12
Section 3 - Expanding Your System
Step 5 Complete setting light levels/
GRAFIK Eye® Scene Selection
Adding a Switch Closure Interface
Press the Program button until the blinking
Program LED turns OFF (approximately 3
seconds).
All Input LEDs will flutter for a few seconds
when completing.
18V
AC IN
Full
Flash
Input 1
Input 2
Input 3
Input 4
Input 5
Common
See the Switch Closure Interface Addendum to the Programming
Guide for operating instructions.
For additional assistance call the
Lutron Technical Assistance
Hotline:
1-800-523-9466
FCC ID JPZ0005
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference and (2) This device must accept any
interference received including interference that may cause undesired operation.
Patents Pending
To Next Page
Loading...
