RadioRA® Setup Guide 3-4
Adding Basic System Components
Step 3 Complete control activation
Press and hold the ACTIVATE CONTROLS
button on any Repeater until the green
ACTIVATE CONTROLS LED turns OFF
(approximately 3 seconds).
To add a Dimmer, Switch or GRAFIK Eye®
Control Unit
Go to the new Dimmer, Switch or GRAFIK Eye®
Control Unit.
Section 3 - Expanding Your System
Turn the Dimmer or Switch ON or OFF by
pressing the tapswitch. Change the selected
scene on the GRAFIK Eye® Control Unit by
pressing any of the preset buttons.
Activate one Dimmer, Switch or GRAFIK Eye
Control Unit at a time. Wait for the Dimmer,
Switch or GRAFIK Eye® Control Unit to flash its
light(s) before activating any remaining
Dimmers, Switches or GRAFIK Eye® Control
Units.
The lights that the Dimmer, Switch or GRAFIK
Eye® Control Unit controls will turn ON and
OFF a few times when it has been activated.
If a Dimmer, Switch or GRAFIK Eye® Control
Unit fails to respond as described above,
consult the Troubleshooting Guide, Sections
V.
?
Repeat the above Step to activate any
remaining Dimmers, Switches or GRAFIK
Eye® Control Units
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
The green ACTIVATE CONTROLS LED on
ALL
Repeaters will turn OFF. The MAIN or
AUXILIARY green LED will remain on.
MAIN
REPEATER
REPEATER
CONTROLS
ACTIVATE
BEEP
FLASH
VERIFY
AUXILIARY
• Controls are now activated.
• If you want to Verify that all new
Controls have been activated, see Flash
Mode in the Troubleshooting Section on
page 4-4.
• For programming instructions, see
Assigning a Column of buttons as
ROOMS or SCENES on page 1-7.
Dimmer Switch
OR
GRAFIK Eye®
Control Unit
To Next Page
Loading...
