36
Pads
To edit one of the Pads when in Preset Edit Mode, press a Pad. You can scroll through the
available parameter values using the Encoder. Select what parameter you would like to edit by
pressing the Encoder.
Channel: The pad will send its messages over this channel. Select the global channel (Global),
a specific channel (Channel 1–16), a zone (Zone 1–4), or all channels (Omni).
Available Values: Global, 1-16, Zone 1-4, Omni
Color 1: Select the primary color that you want to assign to the pad.
Available Values: Off “OFF”, Chartreuse “CHAR.”, Green “GREEN”, Aquamarine “AQUA”,
Cyan “CYAN”, Azure “AZURE”, Blue “BLUE”, Violet “VIOLET”, Magenta “MAGENTA”, Rose
“ROSE”, Red “RED”, Orange “ORANGE”, Yellow “YELLOW”, White “WHITE”.
Color 2: Select the secondary color that you want to assign to the pad.
Available Values: Off “OFF”, Chartreuse “CHAR.”, Green “GREEN”, Aquamarine “AQUA”,
Cyan “CYAN”, Azure “AZURE”, Blue “BLUE”, Violet “VIOLET”, Magenta “MAGENTA”, Rose
“ROSE”, Red “RED”, Orange “ORANGE”, Yellow “YELLOW”, White “WHITE”.
Mode “MODE”:
• Note
“NOTE”: The pad will send its MIDI messages using this Note number.
• CC
“CC”: The pad will send its MIDI messages using this CC number.
• CC Cycle
“CC CYCLE”: The pad will send the value with this CC number when you press
it, one at a time, cycling through them with each press.
• CC Inc/Dec
“CC INC/DC”: The pad will send the next (Increment) or previous
(Decrement) value number in the range of values when you press it.
• Program
“PROGRAM”: The pad will send this program number when you press it.
• Program Cycle
“PRG CYCL”: The pad will send the value with this Program number
when you press it, one at a time, cycling through them with each press.
• Program Inc/Dec
“PG IN/DC”: The pad will send the next (Increment) or previous
(Decrement) program number in the range of programs when you press it.
• Zone
“ZONE”: The pad will activate or deactivate the selected Zones assigned to the
keybed.
When set to Note, these are the available parameters:
Note: The pad will send its MIDI messages using this Note number.
Available Values: C-2 – G8
Latch: When set to Latch On, the pad will send one value when pressed and a different value
when pressed a second time, alternating between the two values with each press. When set to
Latch Off, the pads will send one value when pressed and one value when released.
Available Values: On/Off
Note On: When Latch is active, the pad will send the MIDI note number with this velocity when
you press it to turn it on.
Available Values: 0-127
To Next Page
Loading...
Need help?
General
