47
Note Off: When Latch is active, the Clip button will send the MIDI note number with this
velocity when you press it to turn it off.
Available Values: 0-127
Saving a Preset
To store a Preset:
1. Press SHIFT and the DAW/Preset button to enter Edit Mode. The OLED will display
“EDIT” in the top row, and depending on the current DAW/Preset mode selection, will have
Preset or DAW highlighted in the second row.
Note: When Preset or DAW is highlighted you can turn the Encoder to change from
editing DAW or Preset mode, changing the current selection.
2. Press the Encoder to enter into either DAW or Preset edit mode.
3. Edit a control as outlined in the Preset Edit Mode section of this guide.
4. Press the DAW/Preset button.
5. The display will show “SAVE?” with the following selections available.
• Cancel: Selecting “Yes” to Cancel will revert any changes made.
• Replace: Selecting “Yes” to Replace will write over the currently selected preset.
• Save As: Selecting “Yes” to Save As enable you to choose what number
“LOCATION” the preset will be and edit/change what the preset’s name “NAME” is.
The last available selection in the Save As screen is Save. Pressing “Yes” on the Save
screen will save your new preset.
Note: When editing a preset name, use the Encoder to scroll to a letter you want to edit and
press the Encoder to select the current letter. To erase a letter in a preset name, press SHIFT
and the Back button.
To Next Page
Loading...
Need help?
General
