90
When set to Note, these are the available parameters:
Note: The fader button will send its MIDI messages using this Note number.
Available Values: C-2 – G8
Latch: When set to Latch On, the fader button will send one value when pressed and a
different value when pressed a second time, alternating between the two values with each
press. When set to Latch Off, the fader buttons will send one value when pressed and one
value when released.
Available Values: On/Off
Note On: When Latch is active, the fader button will send the MIDI note number with this
velocity when you press it to turn it on.
Available Values: 0-127
Note Off: When Latch is active, the fader button will send the MIDI note number with this
velocity when you press it to turn it off.
Available Values: 0-127
Pads
To edit one of the Pads when in DAW Edit Mode, press a Pad. You can scroll through the
available parameter values using the Encoder. Select what parameter you would like to edit by
pressing the Encoder.
Channel: The pad will send its messages over this channel. Select the global channel (Global),
a specific channel (Channel 1–16)
Available Values: Global, 1-16
Color 1: Select the primary color that you want to assign to the pad.
Available Values: Off “OFF”, Chartreuse “CHAR.”, Green “GREEN”, Aquamarine “AQUA”,
Cyan “CYAN”, Azure “AZURE”, Blue “BLUE”, Violet “VIOLET”, Magenta “MAGENTA”, Rose
“ROSE”, Red “RED”, Orange “ORANGE”, Yellow “YELLOW”, White “WHITE”.
Color 2: Select the secondary color that you want to assign to the pad.
Available Values: Off “OFF”, Chartreuse “CHAR.”, Green “GREEN”, Aquamarine “AQUA”,
Cyan “CYAN”, Azure “AZURE”, Blue “BLUE”, Violet “VIOLET”, Magenta “MAGENTA”, Rose
“ROSE”, Red “RED”, Orange “ORANGE”, Yellow “YELLOW”, White “WHITE”.
Type “TYPE”:
• Note
“NOTE”: The pad will send its MIDI messages using this Note number.
• CC
“CC”: The pad will send its MIDI messages using this CC number.
• Same as Preset
“PRESET”: When set to PRESET, the pads will send the same message
assigned to the pads when in Preset mode.
To Next Page
Loading...
Need help?
General
