86
Maximum Value: The fader’s maximum position will correspond with this value. You can
reverse the fader’s polarity by making this value smaller than the Minimum value.
Available Values: 0-127
Knobs
To edit one of the Knobs when in DAW Edit Mode, move a Knob. You can scroll through the
available parameter values using the Encoder. Select what parameter you would like to edit by
pressing the Encoder.
Channel: The Knob will send its messages over this channel. Select the global channel
(Global), or a specific channel (Channel 1–16).
Available Values: Global, 1-16
Message “MESSAGE”:
• Mackie
“Mackie”: When set to Mackie Control, you can use the knob with a DAW that
responds to Mackie Control mode.
• Mackie/HUI
“MACK/HUI”: When set to Mackie/HUI, you can use the knob with a DAW
that responds to HUI mode.
• CC “CC”: The fader will send its MIDI messages using this CC number.
CC: The knob will send its MIDI messages using this CC number.
Available Values: 0-127
Minimum Value: The knob’s minimum position will correspond with this value. You can
reverse the knob’s polarity by making this value larger than the Maximum value.
Available Values: 0-127
Maximum Value: The knob’s maximum position will correspond with this value. You can
reverse the knob’s polarity by making this value smaller than the Minimum value.
Available Values: 0-127
To Next Page
Loading...
Need help?
General
