39
When set to Program IN/DC (PG IN/DC), these are the available parameters:
Type: The pad will send the next (Increment) or previous (Decrement) value number in the
range of values when you press it.
Min: The lowest Program value in the range of values will correspond with this setting.
Available Values: 0-127
Max: The highest Program value in the range of values will correspond with this setting.
Available Values: 0-127
When set to Zone, these are the available parameters:
Zone 1: When set to On, the pad will activate Zone 1. When set to Off, the pad will deactivate
Zone 1.
Zone 2: When set to On, the pad will activate Zone 2. When set to Off, the pad will deactivate
Zone 2.
Zone 3: When set to On, the pad will activate Zone 3. When set to Off, the pad will deactivate
Zone 3.
Zone 4: When set to On, the pad will activate Zone 4. When set to Off, the pad will deactivate
Zone 4.
Encoder Turn
To edit the turn functionality of the Encoder when in Preset Edit Mode, press and hold the
SHIFT button and move the ENCODER. You can scroll through the available parameter values
using the Encoder. Select what parameter you would like to edit by pressing the Encoder.
Channel: The Encoder will send its messages over this channel. Select the global channel
(Global), a specific channel (Channel 1–16), a zone (Zone 1–4), or all channels (Omni).
Available Values: Global, 1-16, Zone 1-4, Omni
Message:
• Same as DAW “DAW”: This assignment will match the message assigned to the Oxygen
Pro's current DAW selection's Encoder.
• Program Cycle “PRG CYCL”: This is useful for selecting between different presets in
software or external MIDI hardware. Select from 2-4 program messages.
• Program Inc/Dec
“PG IN/DC”: This is useful to scroll through multiple program
messages.
• CC Cycle
“CC CYCLE”: This useful for controlling from 2 - 4 CC values, as seen on a
button or virtual instrument control with 2-4 parameters. Select from 2-4 values.
• CC Inc/Dec
“CC IN/DC”: This is useful for scrolling through several CC values.
• CC Relative
“CC RELTV”: This is useful for controlling endless Encoders in software.
Select from Right 65, Left 63; Right 63, Left 65; Right 127, Left 01; Right 01, Left 127.
To Next Page
Loading...
Need help?
General
