M-Audio Oxygen Pro Series

68
Faders
To edit a Fader’s controls when in Preset Edit Mode, move a Fader. You can scroll through the
available parameter values using the Encoder. Select what parameter you would like to edit by
pressing the Encoder.
Channel: The Fader will send its messages over this channel. Select the global channel
(Global), a specific channel (Channel 1–16), a zone (Zone 1–4), or all channels (Omni).
Available Values: Global, 1-16, Zone 1-4, Omni
CC: The fader will send its MIDI messages using this CC number.
Available Values: 0-127
Minimum Value: The fader’s minimum position will correspond with this value. You can
reverse the fader’s polarity by making this value larger than the Maximum value.
Available Values: 0-127
Maximum Value: The fader’s maximum position will correspond with this value. You can
reverse the fader’s polarity by making this value smaller than the Minimum value.
Available Values: 0-127
Knobs
To edit one of the Knobs when in Preset Edit Mode, move a Knob. You can scroll through the
available parameter values using the Encoder. Select what parameter you would like to edit by
pressing the Encoder.
Channel: The knob will send its messages over this channel. Select the global channel
(Global), a specific channel (Channel 1–16), a zone (Zone 1–4), or all channels (Omni).
Available Values: Global, 1-16, Zone 1-4, Omni
CC: The knob will send its MIDI messages using this CC number.
Available Values: 0-127
Minimum Value: The knob’s minimum position will correspond with this value. You can
reverse the knob’s polarity by making this value larger than the Maximum value.
Available Values: 0-127
Maximum Value: The knob’s maximum position will correspond with this value. You can
reverse the knob’s polarity by making this value smaller than the Minimum value.
Available Values: 0-127