51
Press: The pad will send the MIDI CC number with this value when you press it.
Available Values: 0-127
Release: The pad will send the MIDI CC number with this value when you release it.
Available Values: 0-127
Encoder Turn
To edit the turn functionality of the Encoder when in DAW Edit Mode, press and hold the
SHIFT button and move the ENCODER. You can scroll through the available parameter values
using the Encoder. Select what parameter you would like to edit by pressing the Encoder.
Channel: The Encoder will send its messages over this channel. Select the global channel
(Global), or a specific channel (Channel 1–16).
Available Values: Global, 1-16
Message:
• Mode: This will specify what message will be sent when the Encoder is turned.
o CC Relative: This is useful to send standard MIDI CC messages to your DAW.
o CC Cycle: This useful for controlling from 2 - 4 CC values, as seen on a button or VI
control with 2-4 parameters. Select from 2-4 values.
o CC Inc/Dec: This is useful for scrolling through several CC values.
o Program Cycle: This is useful for selecting between different presets in software or
external MIDI hardware. Select from 2-4 program messages.
o Program INC/DEC: This is useful to scroll through multiple program messages.
o Mackie Up/Down: This is useful to scroll up/down in a DAW that responds to
Mackie Control Mode.
o Mackie Left/Right: This is useful to scroll left/right in a DAW that responds to
Mackie Control Mode.
o HUI Up/Down: This is useful to scroll up/down in a DAW that responds to HUI
mode.
o HUI Left/Right: This is useful to scroll left/right in a DAW that responds to HUI
mode.
• CC Relative Type: The Encoder will send a value number in the range of values when
you turn it left or right.
o Right 65, Left 63
o Right 63, Left 65
o Right 127, Left 01
o Right 01, Left 127
• CC Cycle Mode Type: The Encoder will send from 2 to 4 values when turned.
• CC Cycle Value: Specifies what CC value will be sent.
• CC: Selects the MIDI CC value that will be sent when the Encoder is turned.
•
Program Cycle Mode Type: T
he Encoder will send from 2 to 4 values when turned.
• Program: Specifies what Program will be sent.
To Next Page
Loading...
Need help?
General
