52
Encoder Press
To edit the press functionality of the Encoder when in DAW Edit Mode, press and hold the SHIFT
button and press the ENCODER. You can scroll through the available parameter values using the
Encoder. Select what parameter you would like to edit by pressing the Encoder.
Channel: The Encoder will send its messages over this channel. Select the global channel (Global), a
specific channel (Channel 1–16)
Available Values: Global, 1-16
Message:
• Mode: This will specify what message will be sent when the Encoder is turned.
o CC: When set to CC, the Encoder will send standard MIDI CC messages to your DAW.
o Program: The Encoder will send its MIDI messages using the selected Program number
and MSB and LSB values.
o Mackie: When set to Mackie Control, you can use the Encoder with a DAW that responds
to Mackie Control mode.
o Mackie/HUI: When set to Mackie/HUI, you can use the Encoder with a DAW that
responds to HUI mode.
• CC: Selects the MIDI CC value that will be sent when the Encoder is pressed.
• Down: The Encoder will send this CC value when you press it.
• Up: The Encoder will send this CC value when you release it.
• Program: The Encoder will send this program number when you press it.
• MSB: The Encoder will send this Bank MSB (Most Significant Byte) number when you press it.
• LSB: The Encoder will send this Bank LSB (Least Significant Byte) number when you press it.
To Next Page
Loading...
Need help?
General
