60
DAW/Preset Button
Editing the DAW/Preset button requires pressing and holding the SHIFT button and pressing
the DAW/Preset button. You can then scroll through the available parameter values using the
Encoder. Select what parameter you would like to edit by pressing the Encoder.
Note: What some parameter values are set to will affect what parameters are available for
editing. For example, if the Button’s Mode parameter is changed from Note to Program, it will
change the editable parameters from Note parameters to Program parameters.
Channel: The DAW/Preset button will send its messages over this channel. Select the global
channel (Global), or a specific channel (Channel 1–16).
Available Values: Global, 1-16
Assignment “ASSIGN”:
• Mackie “MACKIE”: When set to Mackie Control, you can use the button with a DAW that
responds to Mackie Control mode.
• Mackie/HUI “MACK/HUI”: When set to Mackie/HUI, you can use the button with a DAW
that responds to HUI mode.
• Program
“PROGRAM”: The button will send this program number when you press it.
• CC
“CC”: The button will send its MIDI messages using this CC number.
• Off
“OFF”: The button will not send any messages when pressed.
When set to Program, these are the available parameters:
Program: The DAW/Preset button will send this program number when you press it.
Available Values: 0-127
MSB: The DAW/Preset button will send this Bank MSB (Most Significant Byte) number when
you press it.
Available Values: 0-127
LSB: The DAW/Preset button will send this Bank LSB (Least Significant Byte) number when
you press it.
Available Values: 0-127
When set to CC, these are the available parameters:
CC: The DAW/Preset button will send its MIDI messages using this CC number.
Available Values: 0-127
Press: The DAW/Preset button will send the MIDI CC number with this value when you press
it.
Available Values: 0-127
Release: The DAW/Preset button will send the MIDI CC number with this value when you
release it.
Available Values: 0-127
To Next Page
Loading...
Need help?
General
