79
Encoder Press
To edit the press functionality of the Encoder when in Preset Edit Mode, press and hold the
SHIFT button and press the ENCODER. You can scroll through the available parameter values
using the Encoder. Select what parameter you would like to edit by pressing the Encoder.
Channel: The Encoder will send its messages over this channel. Select the global channel
(Global), a specific channel (Channel 1–16), a zone (Zone 1–4), or all channels (Omni).
Available Values: Global, 1-16, Zone 1-4, Omni
Assign:
• Same as DAW “DAW”: This assignment will match the message assigned to the Oxygen
Pro's current DAW selection's Encoder press.
• CC: When set to CC, the Encoder press will send standard MIDI CC messages to your
virtual instrument.
• Program: The Encoder will send its MIDI messages using the selected Program number
and MSB and LSB values.
When set to CC, these are the available parameters:
CC: The Encoder will send its MIDI messages using this CC number.
Available Values: 0-127
Press: The Encoder will send the MIDI CC number with this value when you press it.
Available Values: 0-127
Release: The Encoder will send the MIDI CC number with this value when you release it.
Available Values: 0-127
When set to Program, these are the available parameters:
Program: The Encoder will send this program number when you press it.
Available Values: 0-127
MSB: The Encoder will send this Bank MSB (Most Significant Byte) number when you press it.
Available Values: 0-127
LSB: The Encoder will send this Bank LSB (Least Significant Byte) number when you press it.
Available Values: 0-127
To Next Page
Loading...
Need help?
General
