85
Oxygen 49 and 61 DAW Edit Mode
When SHIFT is pressed and held and the DAW button is pressed, it will enter into editing the
User DAW.
The default parameter to be edited will be the current User DAW’s Fader 1 assignment.
However, once a different control is moved or pressed, for example Knob 1, it will activate that
selected control for editing.
Storing a User DAW
To store a User DAW:
1. Press SHIFT and the DAW button to enter Edit Mode.
2. Edit a control as outlined in the DAW Edit Mode section of this guide.
3. Press the DAW button.
4. The display will show “SAVE?” with the following selections available.
• Cancel: Selecting “Yes” to Cancel will revert any changes made.
• Replace: Selecting “Yes” to Replace will write over the currently selected preset.
• Save As: Selecting “Yes” to Save As enable you to edit/change what the DAW’s
name “NAME” is. The last available selection in the Save As screen is Save. Pressing
“Yes” on the Save screen will save your new User DAW.
Note: When editing a DAW name, use the Encoder to scroll to a letter you want to
edit and press the Encoder to select the current letter. To erase a letter in a DAW
name, press SHIFT and the Back button.
Faders
To edit the Faders controls when in DAW Edit Mode, move a Fader. You can scroll through the
available parameter values using the Encoder. Select what parameter you would like to edit by
pressing the Encoder.
Channel: The Fader will send its messages over this channel. Select the global channel
(Global), or a specific channel (Channel 1–16).
Available Values: Global, 1-16
Message “MESSAGE”:
• Mackie
“Mackie”: When set to Mackie Control, you can use the fader with a DAW that
responds to Mackie Control mode.
• Mackie/HUI
“MACK/HUI”: When set to Mackie/HUI, you can use the fader with a DAW
that responds to HUI mode.
• CC “CC”: The fader will send its MIDI messages using this CC number.
CC: The fader will send its MIDI messages using this CC number.
Available Values: 0-127
Minimum Value: The fader’s minimum position will correspond with this value. You can
reverse the fader’s polarity by making this value larger than the Maximum value.
Available Values: 0-127
To Next Page
Loading...
Need help?
General
