58
When set to Program Cycle, these are the available parameters:
Values: The Clip button will cycle through this many Program values (one at a time) when you press
it: 2 Values, 3 Values, or 4 Values.
Available Values:
• 2 Values
• 3 Values
• 4 Values
First: The Clip button will send this Program message first when you press it.
Available Values: 0-127
Second: The Clip button will send this Program message second when you press it.
Available Values: 0-127
Third: The Clip button will send this Program message third when you press it.
Available Values: 0-127
Last: The Clip button will send this Program message last when you press it.
Available Values: 0-127
When set to Program IN/DC (PG IN/DC), these are the available parameters:
Type: The Clip button will send the next (Increment) or previous (Decrement) value number in the
range of values when you press it.
Min: The lowest Program value in the range of values will correspond with this setting.
Available Values: 0-127
Max: The highest Program value in the range of values will correspond with this setting.
Available Values: 0-127
When set to Note, these are the available parameters:
Note: The Clip button will send its MIDI messages using this Note number.
Available Values: C-2 – G8
Latch: When set to Latch On, the pad will send one value when pressed and a different value when
pressed a second time, alternating between the two values with each press. When set to Latch Off,
the pads will send one value when pressed and one value when released.
Available Values: On/Off
Note On: When Latch is active, the pad will send the MIDI note number with this velocity when you
press it to turn it on.
Available Values: 0-127
Note Off: When Latch is active, the pad will send the MIDI note number with this velocity when you
press it to turn it off.
Available Values: 0-127
To Next Page
Loading...
Need help?
General
