Service Manual – NC-6000 Date: OCT 1
st
, 2012 (Version 1.0)
Masterwork Automodules Tech. Corp., Ltd
Confidential
- 45 -
1. Turn the machine to left side and find the two encoders.
2. Loosen the two screws (M4x6-round head with spring
washer) on the encoder.
*Note1: Take off the encoder before proceeding
disassembly of the machine in order to prevent damaging
them.
*Note2: After assembling the encoders, make sure they are
fixed correctly on the machine or it will cause strange
sounds during operation.
3. Loosen the screw (M3x6-Rround Head with spring
washer)on the both sides of EMI plate and disassemble
it from the machine.
Hold the sides of encoder film
and check if the film are fixed
and not possible to move.
Hold the sides of encoder film
and check if the film are fixed
and not possible to move.
To Next Page
Loading...