Service Manual – NC-6000 Date: OCT 1
st
, 2012 (Version 1.0)
Masterwork Automodules Tech. Corp., Ltd
Confidential
- 46 -
4. Turn the machine to the left side and release the cable
from the cable clamp.
5. Disconnect the two cables which are connected to the
PCB-Motor board.
6. Turn the machine to the rear side and take off the two
plastic e-ring (Ø6) from the shaft of top assembly.
7. Dismount the upper bill path module from the machine.
a. Remove the shaft from the Position (Feed)-L and R.
b. Take off the plastic e-ring (Ø6) from the shaft.
c. Disassemble the top assembly shaft from the
machine.
d. Release the cable from the Square Snap Bushing
8. The upper bill path module is free to be removed from
the machine.
To Next Page
Loading...