Attach
the
Adjustable
Mount
Line
up
the
two
tabs
on
the adjustable mount with
the
holes
on
the
back
of
the cradle.
Once
the
adjustable mount
is
flush with the cradle,
push
the
cradle
and
receiver
assembly
down
until they lock
in
place
with the adjustable mount.
Secure
the
Mount
to
the
Windshield
or
Adhesive
Disk
Make
sure
that the
lever
at
the
base
of the adjustable mount
is
in
the
up
position.
Place
the
base
of
the mount firmly
over
the
area
of the windshield to
be
used
or
the
adhesive
disk.
Push
the
lever
at
the
base
of the mount all the
way
down
until it
snaps
in
place. Carefully let
go
of the
assembly,
making
sure
that it
is
securely mounted.
Adjust
the
Mount
for
Optimum
Viewing
Loosen
the adjustment locking
knobs
and
position the Magellan
Maestro
for optimum viewing.
Once
set,
tighten the locking
knobs.
(Never
attempt
to
adjust the mount while driving.)
Connecting
Power
Plug
the
end
of the cigarette lighter adapter into a
12
VDC
cigarette lighter receptacle
in
the vehicle.
Connect
the other
end
to
the Magellan
Maestro
as
shown.
There
is
a wire catch
on
the
side
of the
cradle to
run
the
power
cable through
to
prevent it
from
disconnecting. If there
is
power
at
the
receptacle, the Magellan
Maestro
will
power
on.
(Note:
some
vehicles apply
power
to the cigarette
lighter receptacle only
when
the ignition
is
on.)
Security
It
is
recommended that the Magellan
Maestro
is
not left
in
plain
view
while unattended for
reasons
of
theft.
The
easiest method for removing the
Magellan
Maestro
once
the mount
is
in
place
is
to
unsnap
it from the cradle
by
pressing
on
the tab
at
the top of the cradle.
Installation
4
To Next Page