Magellan Maestro 4040 - Setting Alarm Parameters; Routing to an Enhanced POI

4. Select Change My POI File.
5. Select Set Alarms.
6. Use the checkbox to the left of the category name to select or deselect the category.
(Checked means this category will have its alarms turned on.)
Tap Mark All to check all categories or Clear All to uncheck all categories.
7. Tap Save when done.
Setting Alarm Parameters
An enhanced POI can have an alarm that will alert you when you are in range set by "Alert
Parameters." Note that all POls in the categories selected will have their alarms set to on. A POI
file must be loaded (see Loading a POI File) for this function to operate.
1. From the Main Menu, tap the Enter Address icon.
2. Select Enhanced.
3. Select
My POI.
4. Select Change My POI File.
5. Select Set Alarms.
6. Select the
category from the category list whose alarm parameters are to be changed.
7. Set the detection angle, the first warning and the last warning by tapping on the button with
the current setti
ng.
8. Use the keypad to enter in new values and tap OK.
9. Tap Save when done.
Routing to an Enhanced POI
A POI file must be loaded (see Loading a POI File) for this function to operate.
1. From the Main Menu, tap the Enter Address icon.
2. Select Enhanced.
3. Select My POI.
4. Select Select Category.
5. Select the category containing the POI you want to route to from the category list.
6. Select Nearest (near your current position) or Spell POI Name (requires entering the POI
name).
7. Select the POI to be routed to from the "Select POI" list.
Points of Interest
30