Danger! Electric shock hazard!
• Only skilled electricians may work on electrical parts of the system!
• Before doing any maintenance work on the system disconnect it from the mains power
supply and secure it against switch on!
• The maintenance work to be by the operator and the appropriate intervals are specified in
the following chapter (this applies if no other changes have been contractually agreed upon).
These kinds of maintenance work may only be done by authorized and trained personnel.
Skilled personnel are those who are authorized and trained by the operator, the manufacturer
and the respective service partner.
Any other maintenance, installation or repair work on the dynamometer during the warranty
period may only be done by MAHA service technicians, those service partners authorized by
MAHA or after consultation and approval by MAHA. The manufacturer warranty becomes
invalid at non-compliance.
• Inform the operating personnel before doing maintenance work.
• The maintenance interval prescribed by the manufacturer is 12 (twelve) months.
This maintenance interval refers to normal workshop usage. If the equipment is used more
frequently or under severe operating conditions (e.g. outdoors), the interval must be reduced
accordingly.
• Maintenance work shall be done only by authorized and trained service technicians provided
by the manufacturer, licensed dealers or service partners.
• In case of non-compliance the manufacturer's warranty becomes void.
12.3 Care Instructions
• Periodically clean the equipment and treat it with a care product.
• Repair damage to the paintwork immediately to prevent corrosion.
• Do not use caustic cleaning agents or high pressure and steam jet cleaners to avoid equip-
ment damage.
To Next Page
Loading...
Need help?
General
