64 BA052301-en
8.4 Starting the Program
1 Switch on the dyno via the main switch on the communication desk.
2 Windows is started after the PC is booted. Depending on the setting, the program is started
either automatically, or by calling up the Start group or by double clicking the icon.
→ The start screen appears with the MAHA logo and version number.
→ The following screen appears which shows the connected PCBs.
The number of modules (PCBs) depends upon the options that have been ordered.
3 Confirm the enabling of the individual dyno components with the
button
4 If desired, start a software update of the individual dyno components
using
→ After a few seconds the main menu appears.
8.5 End Program / Switch off Dyno
First quit the program and then shut down the computer properly. Improper termination can
cause a system crash and data loss!
1 Quit all menu items with <ESC>.
2 As soon as you are in the main menu, quit the program with <F8 EXIT>.
3 Quit Windows and shut down the computer properly.
4 Turn off the main switch at the communication desk.
To Next Page
Loading...
Need help?
General
