Manitowoc Published 03-29-17, Control # 064-23 v2 4-65
14000 OPERATOR MANUAL SETUP AND INSTALLATION
Install Protective Covers on Cab Windows
If equipped, install optional protective covers on windows of
operator’s cab (see Figure 4-7
).
Store Operator’s Cab
See Figure 4-29 for the following procedure.
Rotate operator’s cab (1) to shipping position as follows:
1. Rotate mirror (5, View C) inward against cab for
shipping.
2. Remove hair-pin cotter (3, View B) from top retaining
hole in hitch pin (4).
3. Raise hitch pin (4, View B) to disengaged position
(bottom retaining hole visible) and reinstall hair-pin
cotter (3).
4. Rotate cab (1) 90° to shipping position (View A).
5. Remove hair-pin cotter (3, View B) and lower hitch pin
(4) to engaged position.
6. Reinstall hair-pin cotter (3, View B).
To Next Page
Loading...
