Manitowoc 14000 User Manual

Reference Only
Manitowoc Published 03-29-17, Control # 064-23 3-15
14000 OPERATOR MANUAL OPERATING CONTROLS AND PROCEDURES
3
A6. Battery Disconnect Switch
Turn handle COUNTERCLOCKWISE to CONNECT battery
circuit.
Turn handle CLOCKWISE to DISCONNECT battery circuit
for following reasons:
• When servicing crane’s electrical control system
• If desired, to prevent batteries from discharging when
the crane is stored for extended periods of time
• If desired, to prevent crane from being started by
unauthorized personnel
Pull handle out when in the disconnect position to keep
unauthorized personnel from connecting the battery and
starting the crane.
A7. DPF Switch
NOTE: DPF = Diesel particulate filter (only on cranes with
Tier 4 engine).
The DPF switch is a three position switch. Top position is
momentary. Center and bottom position is maintained.
CENTER position is for NORMAL engine operation.
Regeneration of the DPF will occur automatically.
Press TOP of rocker to START manual stationary
regeneration. Release switch back to center position.
Cummins ECM will control a DPF regeneration if necessary.
It is normal for the DPF High Temperature lamp to illuminate.
Perform a stationary regeneration only if indicated by the
DPF icon in the Tier 4 Engine Information Screen (see Tier 4
Engine Diagnostic Information for details).
NOTE: A guard over the top of the rocker prevents
accidental manual regeneration of the DPF.
Press BOTTOM of rocker to INHIBIT active regeneration.
The amber LED in the rocker will glow.
Use INHIBIT only for special circumstances where it is
desirable to disable active regeneration. Prolonged engine
operation with INHIBIT on will cause the DPF to fill with soot.
Too much soot could cause the engine to stop. If that occurs
it will be necessary to clean the DPF before the engine can
be restarted.
See Engine Manufacturer’s Manual for additional information
regarding stationary regeneration and DPF inhibit operating
instructions.
CAUTION
Engine Damage!
To avoid possible engine fault codes and undesirable
operation, make sure engine ignition switch has been off
five minutes before disconnecting batteries.
Do not rely on this switch to protect crane’s electronic
systems when welding. Disconnect battery cables at
batteries before welding.

Manitowoc 14000 Specifications

General

Brand	Manitowoc
Model	14000
Category	Construction Equipment
Language	English