Manitowoc 14000 User Manual

Reference Only
Manitowoc Published 03-29-17, Control # 064-23 v2 4-93
14000 OPERATOR MANUAL SETUP AND INSTALLATION
4
See Figure 4-43 for the following procedures.
Install Jib Pendants
NOTE: With the exception of the basic pendants, the jib
pendants must be installed in the same sequence
as the inserts.
The jib pendants (and backstay pendants) are
furnished in matched sets of two and must be
installed in matched sets — pendant on one side of
insert must match pendant on other side of insert.
1. Pin basic jib pendants (P1) to lugs on jib top (J2, View
E).
2. Lay pendants on ground.
3. Assemble remaining jib pendants in proper sequence
according to Jib Assembly Drawing. Shortest pendants
must be closest to butt.
4. Pin pendants (P1, P2, or P3) to strut links (3) and to jib
strut (2, View C).
Install Backstay Pendants
See View C for the following procedure.
1. Install backstay links (5).
2. Pin backstay pendants (8) to backstay links (5) and
lower spreader (7).
3. Install upper spreader (6) between strut links (3).
4. Lay backstay pendants (8) on ground alongside boom.
Install Jib Offset Links or Pendants
See View A for the following procedure.
1. Pin backstay links (11) to backstay lugs (12).
2. Depending on jib offset, pin links (9) or pendants (10) to
backstay links (11).
Connect Jib Backstay Pendants
1. Using appropriate slings, attach hook from assist crane
to front side of sheave in jib strut (2).
2. Slowly lift jib strut over center with assist crane. Use
extreme caution not to side load strut while lifting.
3. If required, raise jib point with an outside assist (another
crane or fork-lift truck) to gain enough slack to allow
pinning backstay pendants.
4. Pin backstay pendants (8):
• For 5° offset, to backstay links (11)
• For 15° offset, to offset links (9)
• For 25° offset, to offset pendants (10)

Manitowoc 14000 Specifications

General

Brand	Manitowoc
Model	14000
Category	Construction Equipment
Language	English