OPERATING CONTROLS AND PROCEDURES 14000 OPERATOR MANUAL
3-32
Published 03-29-17, Control # 064-23
6. Maximum Bail Limit
Automatically stops corresponding drum from hoisting when
there is a preset maximum number of wire rope layers on the
drum.
Load can be lowered after the limit is contacted.
The appropriate limit bypass switch must be turned to the
bypass position before the load can be hoisted above the
limit.
7. Minimum Bail Limit
Automatically stops corresponding drum from lowering when
there are three wraps of wire rope remaining on the drum.
Load can be raised after the limit is contacted.
The appropriate limit bypass switch must be turned to the
bypass position before the load can be lowered below the
limit.
SEAT CONTROLS
WARNING
Falling Load Hazard!
Do not exceed maximum allowable spooling capacity
given in Wire Rope Specifications Chart in operator’s cab.
Wire Rope could jump off drum allowing load to fall.
WARNING
Falling Load Hazard!
When lowering load below minimum bail limit, do so
slowly with extreme caution. Do not lower load to point
where less than three full wraps of wire rope are on drum;
wire rope could be pulled out of drum allowing load to fall.
ARMREST
• Open zipper at end of armrest
• Turn bolt clockwise to raise arm rest or
counterclockwise to lower armrest
• Tighten jam nut and close zipper
BACKREST
• Turn knob to raise and lower
backrest to desired position
SEAT FORE-AFT (seat only)
• Push lever to left to unlock
• Use body weight to slide seat to
desired position
• Release lever and make sure it is
latched to lock seat in position
FIGURE 3-16
P1039a
P1041a P1040
SEAT FORE-AFT (seat and consoles)
• Push lever to left to unlock
• Use body weight to slide seat and
consoles to desired position
• Release lever and make sure it is
latched to lock seat and consoles in
position
To Next Page
Loading...
