Maintenance work on the superstructure
8.8 Hoist ropes
8 - 60 3 302 649 en Maintenance manual
GMK4090
07.12.2017
8.8.5 Replacing the hoist rope
Spare parts
and tools
– An original replacement part; à Rope certificate.
– A reel stand with braking block.
– Torque wrench for 79 Nm (58 lbf ft).
Prerequisites – The truck crane must be level.
– The main boom has been set down on the boom rest.
– The hook block is unreeved; à Operating manual.
Replacing the
old rope
• Unreel the hoist rope until it switches off.
• Adjust the lowering limit switch so that you can unreel the rope
completely;
à Setting the lowering limit switch, p. 8 - 63.
• Unreel the remaining layers from the hoist drum.
• Protect the truck crane from unauthorised use; à p. 2 - 3.
S
Risk of accidents due to falling loads
Use only a replacement rope that has the same technical specifications as
the defective rope, or an authentic replacement rope.
G
Risk of accidents due to rotating rope drum
Switch the engine off and remove the ignition key so that no unauthorised
operation of the hoist can occur.
To Next Page
Loading...
Need help?
General
