Manitowoc GROVE GMK4090 - Final Drives - Checking the Oil Level

Maintenance work on the carrier
7.9 Axle lines
07.12.2017
Maintenance manual 3 302 649 en 7 - 61
GMK4090
7.9.4 Final drives – Checking the oil level
Spare parts
and tools
1)
Additional equipment (2nd driven axle line)
Prerequisites – The truck crane must be raised on outriggers and must be level.
– The engine is not running and is secured against unauthorised use;
à p. 2 - 3.
– The parking brake is released.
Checking the
oil level
• Check the oil level at all other final drives in
the same way.
• Turn the wheel until the marking (2) is hori-
zontal and is on the right, next to the centre
of the axle.
• Remove the drain plug (1).
• Check that the oil level is at the mark (2).
• Fit a new gasket and tighten the screw.
If the oil level is too low
• Top up the oil, à p. 7 - 63.
M 1
for drive Designation Quantity GROVE part no.
8 x 6 x 8 Gasket 24 x 29 Cu DIN 7603 6 00117145
8 x 8 x 8
1)
Gasket 24 x 29 Cu DIN 7603 8 00117145