Maintenance work on the carrier
7.3 Engine
07.12.2017
Maintenance manual 3 302 649 en 7 - 13
GMK4090
7.3 Engine
• In addition, carry out additional maintenance work specified in the Engine
manufacturer’s documentation
supplied.
7.3.1 Check the oil level
Prerequisites – The truck crane must be level.
Check the oil level • Start the engine from the driver's cab; à Operating manual.
• Start the engine and watch the symbol (1).
• Stop the engine immediately if the symbol does not disappear
after 10 seconds.
If symbol (1) is displayed, the oil pressure is too low.
• Allow the engine to run at idling speed for 2 – 3 minutes.
• Switch off the engine.
• Check the oil level after about two minutes.
s
S
Risk of damage to the engine if the oil pressure is too low
Switch the engine off immediately if the symbol (1) is displayed.
Running the engine when the oil pressure is too low can damage it.
To Next Page
Loading...
