Run-in regulations
07.12.2017
Maintenance manual 3 302 649 en 4 - 1
GMK4090
4 Run-in regulations
There are regulations about running in individual parts which must be
followed, after:
– First commissioning or
– Replacement of a part or
– General overhaul.
This is why you must carry out additional maintenance work on the carrier
and superstructure at specific intervals:
s
Operating
hours
(oper. hrs.)
Driven km
(mi)
Additional maintenance work on
the CARRIER
after 4 and 24 Check the V-belt on the second alternator
(additional equipment);
à Checking the V-belt tension, p. 7 - 23.
after 50
(30)
Tighten the wheel nuts;
à Special torques, p. 10 - 2.
after 150
(95)
Tighten the wheel nuts;
à Special torques, p. 10 - 2.
after 50 Tighten the clips on the coolant hoses;
à Special torques, p. 10 - 2.
after 100 Lubricate the outrigger beams;
à Lubricating the outrigger beams, p. 7 - 134.
during the
first 100
Check the hydraulic oil filter every week,
and change it if necessary;
à Cleaning the magnetic rods, p. 7 - 93,
à Changing the hydraulic oil filter, p. 7 - 106.
after 100 after 1,000
(650)
Change the drive oil;
à p. 7 - 46 for the transfer case,
à p. 7 - 57 for the axle centre drives,
à p. 7 - 62 for the final drives.
after 250 after 2,500
( 1,550)
Change the engine oil;
à Engine manufacturer’s documentation.
To Next Page
Loading...
Need help?
General
