Grove Published 11-22-2016, Control # 345-12 3-15
RT9130E-2 SERVICE MANUAL ELECTRICAL SYSTEM
15. Disconnect the wire harnesses from the bottom of the
turn signal and transmission shift levers (7).
16. Remove the two bolts and nuts securing the two levers
(7) together.
Installation
1. Align the location pins of the turn signal and
transmission shift levers (7) with the holes in the steering
column.
2. Secure the two levers (7) together using the two bolts
and nuts.
3. Connect the wire harnesses to the levers (7).
4. Install the gauge/switch cover (6) on the steering
column.
5. Connect the wire harness to the bottom of the gauge
cluster (5).
6. Install the wire harnesses on the switches (4) as tagged
during removal.
7. Install the right side cover (9) on the steering column.
8. Connect the wire harness to the ignition switch (10).
9. Install the left side cover (8) on the steering column.
10. Secure the gauge/switch cover (6) to the left and right
side covers (8, 9) using six screws (14).
11. Secure the left and right side covers (8, 9) together using
four screws (13).
12. Install the steering wheel (2); torque the securing nut to
30 lb-ft ±4 (40 Nm ±5).
13. Install the steering wheel cap (1).
14. Install the lever (12) and spacer that locks/unlocks the
steering column tilt/telescope function.
15. Pull the rubber boot (11) up and over the bottom of the
left and right side covers (8, 9).
16. Turn the battery disconnect switch to the ON position.
Check
1. Operate the turn signal lever or transmission shift lever
per the Operator’s Manual. Verify each of its functions
work.
2. As needed, troubleshoot further any system or circuit
malfunction not corrected by repair or replacement of
the signal lever or transmission shift lever or associated
wiring.
To Next Page
Loading...
Need help?
General
