Manitowoc Grove RT9130E-2 - Steering and Suspension

Grove Published 11-22-2016, Control # 345-12 9-7
RT9130E-2 SERVICE MANUAL LUBRICATION
9
Steering and Suspension
Item
Lube Point
Description
Figure
No.
Approved
Lubricant
Lube
Capacity
Lube Interval Application
1
Steer Cylinder
Pivot Pins
Figure 9-1
EP-MPG
Extreme
Pressure
Multipurpose
Grease
6829003477
Until
grease
extrudes
500 hours or 3 months 8 grease fittings
2
Upper and Lower
King Pins
Figure 9-1
EP-MPG
Extreme
Pressure
Multipurpose
Grease
6829003477
Until
grease
extrudes
500 hours or 3 months 8 grease fittings
NOTE:
• Grease the top side bearing of the king pin with the crane on rubber until the grease is observed oozing from the
bearing.
• Grease the bottom side bearing of the king pin with the crane on outriggers (wheels have no contact with ground) until
the grease is observed oozing from the bearing.
• After greasing the bushings, turn/steer the hub ends a few times without load (crane on out riggers).
3
Fifth Wheel
Pivots
Figure 9-1
EP-MPG
Extreme
Pressure
Multipurpose
Grease
6829003477
Until
grease
extrudes
500 hours or 3 months 2 grease fittings
4
Lockout Cylinder
Pivot Pins
Figure 9-1
EP-MPG
Extreme
Pressure
Multipurpose
Grease
6829003477
Until
grease
extrudes
500 hours or 3 months 4 grease fittings
5
Tie Rod Pivot
Pins
Figure 9-1
EP-MPG
Extreme
Pressure
Multipurpose
Grease
6829003477
Until
grease
extrudes
500 hours or 3 months 4 grease fittings