BOOM RT9130E-2 SERVICE MANUAL
4-30 Published 11-22-2016, Control # 345-12
7. Connect the hydraulic hoses to the manifold block
assembly located at the rear of the boom inner mid
section.
8. Remove the retaining bolt from the hose reel to allow
tension to be applied to the hoses.
9. Secure the retaining bolt to the hose reel so the hose
reel is allowed to rotate.
10. Adjust and secure the hose retainer.
Hose Reel Alignment
After hose reel is installed and the attaching bolts properly
torqued, check hose reel to hose guide roller alignment
(Figure 4-6).
1. Check measurements between the hose reel’s hose
flanges and its guide roller (Figure 4-6).
2. Add shims as required to align the hose reel assembly to
the roller within 0.09 in (2.2 mm).
FIGURE 4-6 continued
Hose Reel Alignment
15
0.09 inches
(2.2 mm)
0.09 inches
(2.2 mm)
12
0.25 ±.12 Chain Slack
Measure near the center of span
1, 8
7
9, 10, 11
9, 10, 11
12
VIEW A
To Next Page
Loading...
