Manitowoc Grove RT9130E-2 - Page 301

Grove Published 11-22-2016, Control # 345-12 8-15
RT9130E-2 SERVICE MANUAL UNDERCARRIAGE
8
b. Apply compressed air to the inlet fitting to force the
pistons out of the other housing. If one piston comes
out before the other piston, put a piece of wood in
front of the piston that comes out first. Apply
compressed air to force the other piston out of the
housing (Figure 8-8).
c. Remove the wood block and the C-clamp from the
housing.
d. Remove the pistons (Figure 8-7) from the bores that
are opposite from the mounting plate.
FIGURE 8-7
1
2
3
4
5
6
7
8
9
10
11
Item Description
1 End Plate
2O-ring
3 Backup Ring
4 Dust Seal
5Pistons
6 Housing
7 Bleeder Screw
8O-ring
9 Cylinder Caps
10 Cap
11 Lining Assembly
CAUTION
Do not place hand in front of pistons when forcing them
out. Serious personal injury may occur.
C-Clamp
Piston
Air Gun
Wood
Block
FIGURE 8-8